How to set up Catchbox Lite
To set up your Catchbox, identify your use case first - and then watch the video or use the step-by-step setup instructions provided below:
How to set up Catchbox Lite with an Audio System
- 1
-
Connect the receiver:
- 1. Connect the power supply to the receiver and plug the cord into an AC power source.
- 2. Plug the included audio cable into the receiver's audio output and connect it to the input of your Audio System (mixer board, amplifier, or another audio device).
- 2
- Remove the transmitter from the cover - twist the cylinder 90 degrees to release the magnetic lock and pull it upwards.
- 3
- Turn on both the transmitter and the receiver - the status LED should turn green on both.
-
If transmitter and receiver LED lights aren't solid, this means the units aren't paired.
Pairing the 1st generation Catchbox Lite: Press the pairing button on the receiver and on the transmitter.
Pairing the 2nd generation Catchbox Lite: Press the pairing button on the receiver and press both volume control buttons simultaneously on the transmitter. - Solid LED lights on the transmitter and receiver mean the pairing was successful.
- 4
- Adjust the volume level - test it first by speaking into the microphone and adjust it using the volume knob on the receiver and/or transmitter.
- 5
- Place the transmitter into the cover - make sure to secure the magnetic lock between both! Do this by aligning both black triangle marks on the cover and transmitter. You should hear a slight click when the magnets lock.
How to set up Catchbox Lite with a Computer
- 1
-
Connect the receiver:
- Connect the power supply to the receiver and plug the cord into an AC power source.
- Plug the included USB audio adapter to the computer's USB port and connect it to the receiver's audio output using the provided audio cable.
- 2
- Remove the transmitter from the cover - twist the cylinder 90 degrees to release the magnetic lock and pulling towards.
- 3
- Turn on both the transmitter and the receiver - the status LED should turn green on both.
-
If transmitter and receiver LED lights aren't solid, this means the units aren't paired.
Pairing the 1st generation Catchbox Lite: Press the pairing button on the receiver and on the transmitter.
Pairing the 2nd generation Catchbox Lite:Press the pairing button on the receiver and press both volume control buttons simultaneously on the transmitter - Solid LED lights on the transmitter and receiver mean the pairing was successful.
- 4
- Go to your computer's audio settings and enable the input signal from Catchbox.
- 5
- Adjust the volume level - test it first by speaking into the microphone and adjust it using the volume knob on the receiver and/or transmitter.
- 6
- Place the transmitter into the cover - secure the magnetic lock between both by aligning both black triangle marks on the cover and transmitter. You should hear a slight click when the magnets lock.
Experiencing some trouble with the setup?
If you don't see the solution on the Troubleshooting section on the Catchbox Lite User Manual - talk to us on our live chat or click the "Contact Us" button below!